Remote starter switch hook up

How does a remote starter switch work?

The remote starter switch allows you to turn over or crank the engine without actually running the engine. This comes in handy for conducting certain tests, such as compression or finding the high side of an engine cylinder.

How do you start a car with a remote starter?

Depress the remote starter switch. The engine should now be cranking but not running. Place the vehicle in park and set the emergency brake. Locate the starter on the engine of the vehicle. You may have to crawl under the vehicle slightly to reach the starter motor. Identify the connections on the starter.

How do you hook up a starter relay to a battery?

Place one alligator clamp on the positive side of the battery. This will provide the power to the switch. Place the other alligator clamp of the switch on the small connector of the starter relay. The contacts of the starter relay will then be turning over or cranking the starter.

How do you energize a starter motor switch?

These are used to energize the relay that places the contacts together for energizing the starter motor. Place one alligator clamp on the positive side of the battery. This will provide the power to the switch. Place the other alligator clamp of the switch on the small connector of the starter relay.

How does a remote starter work?

In short, remote starters simulate the engine starting sequence you initiate when you turn on the car with your key. However, a remote car starter does this without a physical key in the ignition. This is made possible when the control module is wired into your ignition switch and other starter mechanisms.

How does a remote start key fob work?

Lots of wires connect to the parts of your car that are responsible for ignition. When you press the button on your remote start key fob, it sends a signal to the components in the car to start the vehicle.

How do you start a car with a remote starter?

Depress the remote starter switch. The engine should now be cranking but not running. Place the vehicle in park and set the emergency brake. Locate the starter on the engine of the vehicle. You may have to crawl under the vehicle slightly to reach the starter motor. Identify the connections on the starter.

How does a remote start work on a Compustar?

Wiring in the Control Module Each part of the Compustar system connects to and communicates with the control module to perform all security and remote start functions, much like the motherboard of a computer. On paper, remote car starters might sound simple: insert a box in the car and use a remote to control the box.

How does a starter motor start a car?

When you turn the ignition key to the START position, the battery voltage goes through the starter control circuit and activates the starter solenoid, which in turn energizes the starter motor. At the same time, the starter solenoid pushes the starter gear forward to mesh it with the engine flywheel (flexplate in an automatic transmission).

How does a starter relay work?

The relay is essentially a remote switch that controls a high-current circuit. In motor vehicles, a starter relay uses the small ignition switch current to close the much heavy-duty starter circuit. In some automotive applications, the starter relay works together with the starter solenoid to operate the starting system.

How do you lower the voltage on a starter motor?

If the car has an inertia-type starter, connect the positive lead to the feed terminal on the starter motor. Touch the negative lead to a bare metal part of the motor for a moment the voltage should drop, but not more than half a volt lower than in the previous test. If it was previously 11 volts,...

How does a pre-engaged starter work?

A pre-engaged starter has the solenoid mounted on the motor casing. The live terminal on the battery is connected by a heavy lead to a terminal on the solenoid switch which is operated when the ignition switch is turned.